Read warnings from Bridgestone Firestone about running tires on too small a diameter chassis dynamometer rolls.

"Reprinted from Bridgestone Firestone's 'Technical Bulletin' online .pdf brochure."

Dyno Tech Talk is a compilation of copyrighted material, however, web sites are welcome to link to our Dyno Tech Talk index page.

dyno-mite chassis dynamometer dyno-mite chassis dynamometer dyno-mite chassis dynamometer dyno-mite chassis dynamometer dyno-mite chassis dynamometer dyno-mite chassis dynamometer 44" diameter dynamometer 44" diameter dynamometer
8½ dia. 12"-13" dia. 20" dia. 24" dia. 30" dia. 36" dia. 44" dia. 60" dia.

© Bridgestone Firestone (reprint)

January 2008      Technical Bulletins

Bridgestone Firestone

Technical Bulletin

October 1995      Ref. No. T9501X

Example of Dyno Tire Damage Bridgestone Firestone
Chassis Dynamometer
Test Guidelines
for Truck/Bus Tires

I. Background
Vehicle manufacturers and many maintenance facilities conduct in-place vehicle testing on twin-roll chassis dynamometers. Testing is usually conducted over a short period of time on empty vehicles. If the following procedure is not adhered to, irreversible damage may occur to the tire.

II. Procedure
To prevent excessive head buildup in the center of the tire tread, follow the recommended time period based on roller diameter as listed below:

Maximum Allowable Time by Roller Diameter

8-5/8" Roller         18" Roller
3.5 minutes         6 minutes

Maximum Allowable Speed is 55 mph.

Load: These time restrictions apply regardless of the actual load, and are, in fact, more critical when the vehicle is tested without a load.

III. Precautions
To avoid the possibility of irreversible tire damage and/or failure during testing, it is important that the following precautions be taken:
• Do not exceed the time and speed restrictions listed in part II.
• Allow at least one hour cool down between tests.
• When it is anticipated that a test will exceed the time/test value established, a worn or “slave” tire should be used in place of the new tire for testing purposes.
Questions regarding test procedures, loads, etc. should be directed to your Regional Field Engineering Office.

Bridgestone Technical Hotline


© Bridgestone Firestone (reprint)