Shielded, or RFI immune optical, cables link DYNOmite DAQs to PCs for advanced report-printing capabilities.

“In the end, data capture and output is the most important function of your dynamometer installation!”

DYNOmite shielded serial-printer and PC-interface cables.Shielded Serial Printer and PC Interface Cables to connect the DYNOmite data-acquisition unit to appropriate serial dot-matrix ASCII printers or to PCs that are using DYNO-MAX software. USB cables feature USB to USB ends with premium shielding to reduce EMI/RFI from engine ignition noise. (USB cables are for DYNOmite-Pro boards with the integral USB option only!) RS232 cables feature male DB-9 to female DB-9 with special shielding and active EMI/RFI filtering circuitry to minimize engine-ignition- noise communication problems. These cables work where others fail!

Part # 430-105 (USB 15' long, for remote console mounting)
Part # 435-126 (RS232 3' long, for printers or attached consoles)
Part # 435-129 (RS232 13' long, for remote console mounting)

DYNOmite USB to RS232 serial-port converter cable.USB to RS232 Serial Port Converter cable adapts most USB-equipped PCs and laptops (that do not have an available RS232 port) to DYNOmite data-acquisition computers, etc. (Note: This cable is not required to use DYNOmite-Pro board sets equipped with the integral-USB option.) Converters feature a six-foot-long shielded cable with a male DB-9 connector on one end and a standard USB connector at the other. Free software drivers for Microsoft Windows (most versions) are included on our DYNO-MAX Demo version 9.3x (and later) CDs.

Part # 430-106 (10' extender cable only - requires #430-116)
Part # 430-116 (USB to RS232 converter cable)

DYNOmite fiber-optic cables to RS232-transceivers kit.Fiber-Optic Cables to RS232 Transceivers Kit offers the EMI and RFI immunity of a bidirectional fiber-optic cable connection between the DYNOmite data-acquisition boards and your RS232 PC or laptop. These units support full-duplex RS232 speed – up to 115K baud rate. AC wall-outlet power supplies are included for PCs unable to directly power the transceiver from their RS232’s line voltage.

Fiber-Optic Cables to USB Transceivers Kit provides the EMI and RFI immunity of a bidirectional fiber-optic cable connection between the DYNOmite data-acquisition boards and your USB PC or laptop. This cable assembly supports either 200 or 1,000 Hertz DYNOmite USB speeds. AC wall-outlet power supply is included for the DYNOmite-side’s transceiver. (Compatible with “non-hub” USB ports on most PCs.)

Part # 435-170 (RS232 transceivers - includes 33' of fiber-optic cabling)
Part # 435-171 (USB transceivers - includes 33' of fiber-optic cabling)